Titanium CP Grade 7 Ti-Pd

Common Name
CP Grade 7 CP Grade 7
CP Grade 2 with Palladium CP Grade 2 with Palladium
UNS
R52400
General Information
Titanium Alloy Grade 7 with 0.1% palladium is similar to Grade 2, but with improved resistance to general and localized crevice corrosion in a wide range of reducing acid environments, including chlorides, and where low pH and high temperatures above 180ºF (83ºC) to 500ºF (260ºC) are prevalent. The alloy is available as castings, wire, welded tube, pipe, plate, sheet, strip, forgings, bar, and billet.
Common Specification
Specification
ASME SB-265 ASME SB-265
Sheet, Strip and Plate Sheet, Strip and Plate
ASTM B265 (Grade 7) ASTM B265 (Grade 7)
ASME SB-348 ASME SB-348
ASTM B265 (Grade 7) ASTM B265 (Grade 7)
ASTM B348 (Grade 7) ASTM B348 (Grade 7)
ASTM B367 (Grade 7) ASTM B367 (Grade 7)
ASTM B861* ASTM B861*
ASTM B862* ASTM B862*
AWS A5.16 (ERTi-7) AWS A5.16 (ERTi-7)
Chemistry Requirements
N C H Fe O Pd Residual Each Max Residuals Max Total Ti
0.05 0.08 0.015 0.30 0.25 0.12-0.25 0.1 0.4 Balance

% Maximum unless given as a range.

Minimum Tensile Properties
Condition UTS ksi (Mpa) >0.2%YS ksi (MPA) % El. % RA*
As specified (shape) 50 (345) 40 (275) 20 30

CP GRADE 7-4

Typical Tensile Properties
Condition UTS ksi (Mpa) >0.2%YS ksi (MPA) % El. % RA*
As provided 70 (483) 51 (352) 28

Note: Typical properties are not to be utilized as a requirement, but are only listed for guidance. These properties may or may not be attainable in all circumstances.
* %Ra not required by all specifications
 
Trademark Notice: Some names are trade names and/or trademarks of specific manufacturers. PT. Special Metals Indonesia is not affiliated with any manufacturer(s). Orders will be filled to meet specifications from any available source(s). Names are listed solely for reference to help identify products consistent with listed specifications.

Titanium CP Grade 7 Ti-Pd

× Contact Us